Remove your Webson Gill Writing instrument from its case
Getting Started With Your Webson Gill
Components Of Your Webson Gill
Instructions
-
1. Preparing For Ink
-
2. Installing Webson Gill Ink Cartridge
-
3. Installing Refillable Ink With Converter
-
4. Creating Ink Flow
01
02
Admire its beauty
03
Unscrew the cap
01
Remove the pre installed converter
Image Coming Soon
02
Insert Webson Gill Ink Cartridge
01
Insert nib into ink
Make sure the entire nib is submerged up to the start if the section
Image Coming Soon
Image Coming Soon
02
Screw the converter all the way to the bottom and slowly screw it back up drawing ink
Repeat until there are no air bubbles in the converter
Note: There will be an air pocket at the top of the converter when it is full of ink. That is completely normal.
03
Wipe off access ink with paper towel
Note: Hold the tip of the nib to an absorbent paper towel to extract any excess ink from the nib
01
Rescrew the barrel into the section
02
Hold the pen inverted with the nib pointing down
03
Hold the writing instrument as if you are about to write
04
Make small half inch strokes on the paper
Make sure you are pressing firmly and can see the tip of the nib separating
If the ink is still not flowing after 50 strokes, run warm water over the nib and repeat